HP rp5800 Maintenance And Service Manual page 88

5. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive
toward the front of the computer until it locks into place.
Figure 7-40
6. Rotate the drive cage to its upright position.
7. Connect the power cable and data cable to the rear of the optical drive.
NOTE:
system board to the primary hard drive, then to the secondary hard drive, then to the rear of the
optical drive.
8. Connect the SATA data cable to the black eSATA connector on the system board labeled
SATA2 unless an eSATA adapter is installed. If an eSATA adapter is installed, connect the
SATA data cable to the light blue SATA connector on the system board labeled SATA1.
NOTE:
board drive connectors.
9. Route the data cable through the cable guides.
CAUTION:
drive cage when raising or lowering it. One is located on the bottom side of the drive cage. The
other is located on the chassis frame under the drive cage. Ensure that the data cable is routed
through these guides.
10. Rotate the drive cage back down to its normal position.
CAUTION:
11. Reassemble the computer.
78 Chapter 7 Removal and Replacement Procedures
Installing the Optical Drive
The power cable for the optical drive is a three-headed cable that is routed from the
Refer to System Board Drive Connections on page 75
There are two cable guides that keep the data cable from being pinched by the
Be careful not to pinch any cables or wires when rotating the drive cage down.
for an illustration of the system