HP rp5800 Maintenance And Service Manual page 113

5. After disengaging the partition from the rear of the chassis, lift the partition to disengage it from
the front of the chassis (3), and then remove the partition from the computer (4).
Figure 7-66 Removing the 50°C heat partition
To install the 50°C heat partition, reverse the removal procedures.
When replacing the partition, note the following items.
A tab near the front on the side of the partition slides into a clip on the side of the drive cage.
Figure 7-67 Installing the partition – attaching to side of optical drive cage
A cap on the bottom of the partition fits over a screw on the heat sink.
50°C configuration components 103