Connecting To A Gps Receiver - Uniden UM415BK Owner's Manual

1. Connect the BLACK wire of the power cable to the NEGATIVE (-) side of your power
source.
2. Connect the RED wire of the power cable to
the POSITIVE (+) side of your power source.
3. NOTE: To extend the life of the radio,
use waterproof tape to seal electrical
connections.
4. Install your antenna according to the
manufacturer's instructions.
5. If necessary, consult the FCC guidelines for
antenna separation. See Antenna Selection
and Installation on page 51 for more
details. (In summary, the FCC recommends
that antennas up to 3 dB be installed a minimum of 3 feet from any occupied location;
antennas over 3 dB should be installed at least 6 feet away.)
6. Connect the PL-259 connector from the antenna lead-in wires to the SO238 connector
labeled
ANTENNA
If you connect the radio to a GPS receiver, the radio can automatically transmit your current

Connecting to a GPS receiver

position during an automated distress call or during a normal DSC call.
Your radio supports a standard NMEA0183 input from a GPS receiver. Follow the steps
below to connect your radio to your GPS receiver:
13.8V DC 13.8V DC
 English
on the back of your radio.
Radio connector, Radio connector,
SO238 (female SO238 (female
PL-259) PL-259)
13.8V DC 13.8V DC
Antenna lead-in Antenna lead-in
connector, connector,
male PL-259 male PL-259
Orange: NMEA OUT (-) Orange: NMEA OUT (-)
Black: Ext. Speaker (-)/GND Black: Ext. Speaker (-)/GND
Green: GPS Data IN (+) Green: GPS Data IN (+)
Red: External Speaker (+) Red: External Speaker (+)
Bare wire: Ground Bare wire: Ground
Yellow: NMEA OUT (+) Yellow: NMEA OUT (+)
Red wire Red wire
(+) (+)
Black wire Black wire
(-) (-)