Cisco SRST - 881 EN Security Router Wireless Manual page 38

Configuration
Issue the following CLI command:
Step 2
Show voice register pool <pool #>
Verify the show voice register response is similar to the following:
Step 3
SRST-Router#sh voice regi pool 1
Pool Tag 1
Config:
Network address is 1.4.196.0, Mask is 255.255.255.0
Proxy Ip address is 1.4.196.1
DTMF Relay is disabled
Dialpeers created:
dial-peer voice 40001 voip
destination-pattern 5001
redirect ip2ip
session target ipv4:1.4.196.41:25672
session protocol sipv2
dial-peer voice 40002 voip
destination-pattern 5001
redirect ip2ip
session target ipv4:1.4.196.1:5060
session protocol sipv2
monitor probe rtr 1.4.196.1
dial-peer voice 40003 voip
destination-pattern 5002
redirect ip2ip
session target ipv4:1.4.196.41:25672
session protocol sipv2
dial-peer voice 40004 voip
destination-pattern 5002
redirect ip2ip
session target ipv4:1.4.196.1:5060
session protocol sipv2
monitor probe rtr 1.4.196.1
Statistics:
Active registrations
Total Registration Statistics
Registration requests
Registration success
Registration failed
unRegister requests
unRegister success
unRegister failed
Step 4 Issue the following SNMP request:
Getmany -v2c <ip addr> test csrstSipEndpointTable
Step 5 Verify the response for the getmany request is similar to the following:
moki:1919> getmany -v2c 1.4.196.1 test csrstSipEndpointTable
csrstSipVoRegPoolEdptTag.0 = 1
csrstSipVoRegPoolEdptTag.1 = 1
csrstSipVoRegPoolEdptTag.2 = 1
csrstSipVoRegPoolEdptTag.3 = 1
csrstSipEndpointIpAddrType.0 = ipv4(1)
csrstSipEndpointIpAddrType.1 = ipv4(1)
Cisco SRST SNMP MIB Release 3.4 Guide
1-24
: 4
: 4
: 4
: 0
: 0
: 0
: 0
Chapter 1 Cisco SRST SNMP MIB Support
OL-7959-01