TP-Link TL-WR541G - Wireless Router User Manual page 38

should do as following:
1. Select Enable Bridges and input 00-13-56-A8-9E-1B as following screen shown.
2. Access the AP's Web-based utility and configure the AP under Bridge mode, then input
00-13-56-A8-9E-1A in corresponding Blank.
Enable Wireless Security – The wireless security function can be enabled or disabled. If
disabled, the wireless stations will be able to connect the router without encryption. It is
recommended strongly that you choose this option to encrypt your wireless network. The
encryption settings are described below.
Authentication Type - You can select one of the following authentication types:
•
WEP - Select WEP authentication type based on 802.11 authentications.
•
WPA-PSK/WPA2-PSK - Select WPA/WPA2 authentication type based on pre-shared
pass phrase.
•
WPA /WPA2 - Select WPA/WPA2 authentication type based on Radius Server.
Authentication Options - You can select one of the following authentication options:
•
When you select WEP for authentication type you can select the following
authentication options:
•
Automatic - Select Shared Key or Open System authentication type automatically
based on the wireless station request.
•
Shared Key - select 802.11 Shared Key authentications.
•
Open System - Select 802.11 Open System authentications.
•
When you select WPA-PSK/WPA2-PSK for authentication type you can select
Automatic, WPA –PSK or WPA2-PSK as authentication options.
•
When you select WPA/WPA2 as an authentication type you can select Automatic WPA
or WPA2 as authentication option.
31