Boot To Dell Iso On Network Task; Copy Windows 2008 Soi Drivers Task - Symantec ALTIRIS DEPLOYMENT SOLUTION 7.1 - FOR DELL SERVERS V1.0 Manual

Boot to Dell ISO on network task

Copy Windows 2008 SOI drivers task

See "Creating a deployment task for a Dell server"
This task contains the following options after you click Advanced:
Script tab
You can choose to save the script output with the task status.
Run options tab
You can choose to allow other tasks to run while this task is running.
You can also choose to end the task after the number of minutes that you
specify. The default is 30 minutes.
This task type lets you boot to a Dell-specific WinPE ISO. You can boot to the Dell
pre-OS ISO on the deployment share without using PXE.
This task type is one of several that can be included in a scripted OS installation
job.
See "Performing a scripted OS installation without PXE"
If you boot to Linux, you cannot use any of the functionality that Deployment
Solution for Dell specifically provides. If you boot to Windows, you can use the
same functionality as if you PXE booted to WinPE.
You can access this task type from the Create New Job or Task page.
See "Creating a deployment task for a Dell server"
This task contains the following options:
You can select a Dell WinPE for a 32-bit, 64-bit, or Linux operating system.
Advanced
Script tab
You can choose to save the script output with the task status.
Run options tab
You can choose to allow other tasks to run while this task is running.
You can also choose to end the task after the number of minutes that you
specify. The default is 30 minutes.
This task type lets you copy drivers from the iDRAC to the RAM drive before you
perform a scripted OS installation (SOI) of Windows 2008.
See "Performing a scripted OS installation without PXE"
Performing a scripted OS installation
Boot to Dell ISO on network task
on page 26.
on page 37.
on page 26.
on page 37.
41