Table of Contents
Advertisement
Connecting a television with AUDIO/VIDEO, S-VIDEO or COMPONENT VIDEO
terminals and VCR
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
4
1
To household mains socket
(AC 220–240 V, 50 Hz)
AC mains lead
Connect only after all other
connections are complete.
Audio/Video cable
4
AC IN
This unit's rear panel
Cooling fan
Audio/Video cable
VCR's rear panel
∫ Component video output
Component signal outputs the colour difference signals (P
reproducing colours. If the television is compatible with progressive output, a high quality picture can be output because this unit's component
video output terminal outputs a progressive output signal ( page 42).
For progressive output ( page 10)
∫ Connecting to a television with 21-pin Scart
terminal
You can also connect with the AV1 terminal on this unit using the
21-pin Scart cable.
If your television is equipped with RGB input capability, by
connecting with a fully wired 21-pin Scart cable you can see video
using RGB output on this unit.
To output in RGB select "RGB (without component)" from "AV1
Output" in the SETUP menu ( page 37).
RGB refers to the three primary colours of light, red (R), green (G),
and blue (B) and also the method of producing video that uses
them. By dividing the video signal into the three colours for
transmission, noise is reduced for even higher quality images.
When making this connection, ensure you
connect the audio cables to the corresponding
audio input terminals on the television.
Television's
rear panel
AUDIO IN
VIDEO IN
S-VIDEO IN
R
L
Red White Yellow
S-Video
cable
3
Red White Yellow
R - AUDIO - L
VIDEO S-VIDEO
OPTICAL
R - AUDIO - L
VIDEO
S-VIDEO
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
S-VIDEO OUT terminal
Red White Yellow
The S-VIDEO OUT terminal achieves a more
vivid picture than the VIDEO OUT terminal.
(Actual results depend on the television.)
COMPONENT VIDEO OUT terminal
These terminals can be used for either interlace or
progressive output and provide a purer picture than the
S-VIDEO OUT terminal ( below).
≥Connect to terminals of the same colour.
Red White Yellow
R
L
AUDIO OUT VIDEO OUT
/P
) and luminance signal (Y) separately in order to achieve high fidelity in
B
R
COMPONENT
VIDEO IN
RF coaxial cable
Video cable
AV1 (TV)
AV2 (DECODER/EXT)
∫ Connecting to a VCR with 21-pin Scart terminal
You can also connect with the AV2 terminal on this unit using the
21-pin Scart cable.
To input in RGB select "RGB (Not NTSC)" from "AV2 Input" in
the SETUP menu ( page 37).
To the aerial
VHF/UHF
RF IN
Splitter
Aerial
cable
2
1
Y
RF IN
P
B
P
R
COMPONENT
RF OUT
VIDEO OUT
(NTSC:480P/480I,
PAL:576P/576I)
Use a splitter if
you also want
to connect the
aerial to your
VCR.
VHF/UHF
RF IN
RQT7444
7
Hide quick links:
Advertisement
Table of Contents
