4. Deck outer spindle
Lubricate using a grease gun, one zerk, each side 2-3
strokes. Use only good quality bearing grease.
WARNING!
Engine oil can be very hot
if it is drained directly after
stopping the engine. Allow
the engine to cool to a safe
temperature fi rst.
Engine Oil
5. Engine Oil Filter
•
Drain the engine oil in accordance with the
work description under the heading Engine
Oil/Change Engine Oil.
•
Remove the oil fi lter. If necessary, use a
fi lter remover.
•
Wipe new, clean engine oil onto the seal
for the new fi lter.
•
Mount the fi lter by hand with +¾ turn.
•
Run the engine warm, then check that
there are no leaks around the oil fi lter seal.
•
Check the oil level in the engine, fi ll
if necessary. The oil fi lter holds 0.1 qt (0.1
liters) of oil.
50
-
English
LUBRICATION
Deck outer spindle (with belt shield removed)
Changing the oil fi lter
IMPORTANT INFORMATION
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
water in case of spills.
8011-733
8011-734