THUNDER TIGER MINI TITAN V2 - MANUAL 2 Instruction Manual page 45

Heli Accessories /
BLADE BALANCER 主旋翼平衡器
USERS GUIDE 使用說明
Dynamic Balance 動平衡
1. Open the Blade Rack.
打開旋翼架
Blade Rack and mark at
the same side
旋翼架與記號線在同側
3. Use the Calibration Weight to reset the bridge and
make sure the bridge is leveled via inspecting the
level.
使用平衡重錘率定平衡器，
並觀察水準氣泡是否位於中間位置。
Static Balance 靜平衡
1. Use the Calibration Weight to reset the bridge and
make sure the bridge is leveled via inspecting the level.
使用平衡重錘率定平衡器，並觀察水準氣泡是否位於中間
位置。
3. Pull the blades all the way straight so that you can check
the weight of the blades and do the balancing.
確定兩主旋翼呈一直線以進行靜平衡調整。
NOTE / 注意事項
For blades length above 550mm, please open the Balance Wing.
For 4mm bolt holes, please use the collar included.
For 5mm blot holes, please turn over the Mounting Cap.
量測550mm以上主旋翼，請打開平衡翼。
4mm的主旋翼固定孔，請使用內附的軸套。
5mm的主旋翼固定孔，請將固定螺母倒轉。
Item No. / 料號：1077
2. Attach the Seesaw Bridge with the Bearing Lock.
將蹺蹺板以軸承扣固定
4. Place the blade on the rack then you can mark the
C.G. when the bridge is leveled.
將旋翼置於旋翼架上尋找重心，並在重心位置上作記號。
2. Put the blades on the Seesaw Bridge and secure them
with the Thumb Screw.
將主旋翼鎖至蹺蹺板上。
Leading edge
翼前緣方向
parallel
平行
FOR 4MM BOLT HOLES
4MM主旋翼固定孔
This side up
凸緣向上
-44-
Leading edge
翼前緣方向
FOR 5MM BOLT HOLES
5MM主旋翼固定孔
Collar
d3xD4x10W
軸環
This side down
凸緣向下