Charging The Glow Plug Igniter; Preparing The Radio - THUNDER TIGER MTA4 Instruction Manual

CHARGING THE GLOW PLUG IGNITER

6
Thunder Tiger Optional Part #2165, 1300MAH Glow Starter w/220V Charger.
Thunder Tiger Optional Part #2166, 1300MAH Glow Starter w/110V Charger.
Thunder Tiger Optional Part #2164, 1300MAH Glow Starter w/240V Charger.
a
d
a.
Plug the charger into an AC outlet.
b.
Line up the charging adapter with the tip of the glow plug igniter.
c.
Pull on the glow plug igniter lever to accept the charging adapter.
d.
Plug the charging adapter into the glow plug igniter. At this point, the small red LED indicator on the
charger should light up indicating the charging sequence is in progress.
e.
Unplug the glow plug igniter from charger after charging is complete. Pull on the glow plug igniter
lever.
f.
Pull the charging adapter out of the glow plug igniter.
Charge the new glow plug igniter for 16 to 24 hours on the first charge. For subsequent charges, charge
it about 12 hours before next use.
NOTE :
If the igniter gets warm or hot during the charge, unplug the igniter from charger immediately. A warm /
hot igniter means the igniter is overcharged. Overcharging can damage the internal battery in the igniter;
thus, shortening its life.

PREPARING THE RADIO

7
a
a.
Install the antenna into transmitter.
b.
Check the frequency printed on the transmitter crystal.
c.
Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter
crystal. Make sure no one will operate on the same frequency when you are. When there is a radio
glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the
same frequency.
b
e
b
5
c
f
c