Unwrapping Contents From Box; Charging The Glow Plug Igniter; Installing Tires / Wheels - THUNDER TIGER ER-1 Instruction Manual

1

UNWRAPPING CONTENTS FROM BOX

a
a.
Contents of the box are secured with reusable zip-ties. To unlock zip-tie, press on the small lever.
b.
Pull on the zip-tie while keeping the small lever pressed. Pull the zip-tie out completely.

CHARGING THE GLOW PLUG IGNITER

2
a
a.
Plug the charger into an AC outlet, and then pull on the igniter lever to accept the charging adapter.
b.
At this point, the small red LED indicator on the charger should light up indicating the charging sequence
is in progress.
c.
When the charging complete, pull on the glow plug igniter lever to unplug the glow igniter.
Charge the new glow plug igniter for 16 to 24 hours on the first charge. For subsequent charges, charge
it about 12 hours before next use.
NOTE:
If the igniter gets warm or hot during the charge, unplug the igniter from charger immediately. A warm /
hot igniter means the igniter is overcharged. Overcharging can damage the internal battery in the igniter;
thus, shortening its life.
3

INSTALLING TIRES / WHEELS

a
a.
Insert the axle pin into the hole.
b.
Apply the supplied lock nuts onto the wheel axle.
c.
Turn the wrench to tighten the wheel nuts
b
b
b
c
c