Viewing The Event Buffer From A Pk5500/Lcd5500 Keypad; Pk5500 Global Status Screen; Sensor Reset - DSC PC-1616 - REV2 User Manual

Refer to the following chart:
[1] - A, B, C, 1
[2] - D, E, F, 2
[3] - G, H, I, 3
[4] - J, K, L, 4
[5] - M, N, O, 5
7. When the required letter or number is displayed use the arrow keys (
8. When you are finished programming the Zone Label, press the
9. Continue from Step 2 until all Labels are programmed.

Viewing the Event Buffer from a PK5500/LCD5500 Keypad

The event buffer will show you a list of the last 500 events that have occurred on your system. You must use an
LCD keypad to view the event buffer.
1. Press [Master Code].
2. To select Event Buffer viewing, press
3. The keypad will display the event number, partition or area, and the time and date. Press
between this information and the event details.
4. Use the keys to scroll through the events in the buffer.
5. To exit event buffer viewing, press

PK5500 Global Status Screen

When the keypad is loaned to global mode (pressing and holding the
tus screen. This shows basic status for up to 8 partitions, depending on the configuration of your system. The
screen looks similar to the example shown below.
Each partition is identified by a number. Below each number is the current status of that partition.
- Partition is Armed
A
- Partition is Not Ready to Arm
N
- Partition is Ready to Arm
R
- Partition is in Alarm
!
-
- Partition is Not Enabled

Sensor Reset

Certain sensors, after having detected an alarm condition, require a Reset to exit the alarm condition (i.e. glass
break sensors, smoke detectors, etc.). Ask your alarm company if this function is required on your system.
To reset the detectors, press and hold the Reset key for 2 seconds or press
If a sensor fails to reset, it may still be detecting an alarm condition. If the sensor reset is successful, the alarm is
cancelled. If unsuccessful, the alarm will reactivate or continue.
[6] - P, Q, R, 6
[7] - S, T, U, 7
[8] - V, W, X, 8
[9] - Y, Z, 9,0
[0] - Space
.
.
1 2 3 4 5 6 7 8
A R ! N - - - -
key, scroll to "Save," then press
key), you will see a Global Partition Sta-
16
) to scroll to the next letter.
to switch
.
.