IBM 84875MU User Manual page 48

Complete the following steps to install a hot-swap hard disk drive:
1. Read "Installation guidelines" on page 23 and the safety information beginning
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Unlock the side cover.
4. Slide the drive-bay lock bar to the left to access the drive bays.
5. Remove the filler panel from one of the empty hot-swap bays by inserting your
6. Touch the static-protective package containing the drive to any unpainted metal
7. Install the hard disk drive in the hot-swap bay:
8. If you are installing additional hot-swap hard disk drives, do so now.
38
xSeries 206 Type 8482 and 8487: Hardware Maintenance Manual and Troubleshooting Guide
at "Safety information" on page 107.
external cables.
Note: If the server is configured for RAID operation, the installed drive may not
be recognized and reconfigured by RAID until the server is turned off and
turned back on.
finger into the depression at the left side of the filler panel and pulling it away
from the server.
surface on the server; then, remove the drive from the package and place it on
a static-protective surface.
a. Make sure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently slide the drive assembly into the drive bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
Note: If your server is configured for RAID operation using an optional
ServeRAID controller, you might have to reconfigure your disk arrays
after installing hard disk drives. See the ServeRAID documentation on
the IBM ServeRAID Support CD for additional information about RAID
operation and complete instructions for using ServeRAID Manager.
Drive bay
lock-bar
Filler panel
Drive tray
assembly
Drive tray handle
(in open position)