IBM 7979B1U User Manual page 76

17. Temporarily disconnect the hard disk drive backplane signal cable from the
18. Route the SCSI signal cable to the supported SCSI adapter that is installed in
19. Connect the tape-drive power cable to the tape-drive power connector, J100
20. Replace the hard disk drive backplane signal cable, making sure that it passes
21. Reconnect the hard disk drive backplane signal cable to the connector on the
60
System x3650 Type 7979: User's Guide
connector on the system board (J92), remove the cable from the cable clamp,
and set the cable aside. See "System-board internal cable connectors" on
page 19 for the location of the connector and cable clamp.
slot 1 of the riser-card assembly, as shown in the following illustration. Make
sure that the cable passes through the cable clamp.
Important: Make sure that the cables avoid any fan connectors.
(see "System-board internal cable connectors" on page 19 for the location of
the power connector).
through the cable clamp on top of the SCSI signal cable. Close the cable
clamp.
system board.
SCSI signal
cable
Cable clamp