IBM 7979B1U User Manual page 72

10. Push the tray handle to the closed (locked) position.
11. Remove the backing from the terminator hook-and-loop fastener. With the
12. Remove the riser-card assembly and the DIMM air baffle (see "Removing the
13. Temporarily disconnect the hard disk drive backplane signal cable from the
14. Route the SCSI signal cable to the supported SCSI adapter that is installed in
56
System x3650 Type 7979: User's Guide
7. From the inside of the server, thread the tape-drive end of the cables through
the slot in the left side of the hard disk drive cage and out the front of the
server.
Note: The terminator on the short section of the cable does not go through
the slot; do not attempt to force it.
8. Connect the cables to the back of the tape drive.
9. Push the tape-drive assembly into the bays, gently pulling the cables farther
into the server as you do so, until the tape-drive assembly stops.
hook-and-loop-fastener side down, orient the terminator as shown in the
following illustration and press the terminator onto the top of the CD/DVD drive
bay.
riser-card assembly" on page 32 and "Removing the DIMM air baffle" on page
36).
connector on the system board (J92), remove the cable from the cable clamp,
and set the cable aside. See "System-board internal cable connectors" on
page 19 for the location of the connector and cable clamp.
slot 1 of the riser-card assembly, as shown in the following illustration. Make
sure that the cable passes through the cable clamp.
Important: Make sure that the cables avoid any fan connectors.
SCSI terminator