Converting The 4.0 Remote Control - Dish Network 3.1 User Manual

C
ONVERTING THE
By replacing the key at the bottom of the 4.0 remote, this remote can be
converted to look and work like a 3.0 IR or to operate like a second
UHF Pro remote to control the
instructions below show you how to replace this key. After replacing
the key, follow the instructions in Setting Up to Control the Satellite
Receiver.
Note: If you do not need to replace the key, you do not need to
complete the instructions below. Go to Setting Up to Control the
Satellite Receiver.
1. Slide the battery cover off.
2. Insert your thumbnail in the
seam between the remote
control and the blue key to
separate the key.
3. Grasp the key at the bottom and pull down firmly to remove.
4. If you are converting the remote
to look and work like a 3.0 IR
remote, then turn the removed
key over with the green 1 side
up (this key should not have a
UHF Pro marking). Reinstall
the key with the green side
showing. Make sure the key
snaps in place.
4
4.0 R
EMOTE
side of the DISH 322 receiver. The
C
ONTROL
Note: Key
has no UHF
Pro marking.