Program The Remote To Control Your Tv - Dish Network 301 Setting Up

5.

Program the Remote to Control Your TV

Use the "Remote Control TV Codes" booklet that was included with your replacement
remote to find the code needed for your TV.
A
While facing the TV
where the remote
will be used, press
and hold the TV
mode button.
B
Enter the three-digit
remote control code
from the "Remote
Control TV Codes"
booklet.
C
Press and release
the POUND (#)
button.
D
Press and release
the large, red
POWER button.
E
Press and release
the SAT mode
button.
F
Press and release
the TV POWER
button. Then, press
VOLUME up or
down to confirm
that the remote
operates your TV.
Congratulations! You are now ready to enjoy DISH Network.
* If your TV does not respond to the DISH remote, try another three-digit remote control TV code.
Go to dish.com/support
setting up your remote to function in Limited and SAT Auto Tune modes.
for instructions on programming your remote using Power Scan or for
All four mode
buttons will
light up.
The TV
mode button
will light up.
The TV
mode button
will flash
three times.
The TV will
turn off.
The SAT
mode button
will light up.
The TV will
turn on and
respond to
remote
commands.*
VOL