Setting Up To Control The Satellite Receiver - Dish Network 3.1 User Manual

5. If you are converting the remote
to operate like a second UHF
Pro remote to control the
side of the DISH 322 receiver,
then get the green 1 UHF Pro
key provided separately. Install
this key in the remote with the
UHF Pro marking showing.
6. If you have not already installed batteries, install them now.
See Installing Batteries for further details.
7. Slide the battery cover back into place.
S U
ETTING
R
ECEIVER
The remote and the receiver must be set up on the same address
so that the remote can control the receiver. When you get the remote,
it's already set up to control the receiver on address 1. However, your
receiver may be set to a different address or, in the case of the
DISH 322, may need some additional setup. To set up the remote
and receiver to work together on the same address, use the following
instructions.
If you set up your DISH 322 to operate the
side using UHF Pro, the two UHF Pro remotes
for this receiver will interfere with each other
when operated at the same time. This may
prevent the remotes from operating the receiver
momentarily.
C
P TO ONTROL THE
Note: Key has the
UHF Pro marking.
S
ATELLITE
5