Installing The Receiver - Dish Network 138410 User Manual

Chapter 2
Receiver Description and Installation

Installing the Receiver

Connecting Your Receiver to an HDTV or HD Monitor
Page 20
This section guides you through the installation of your new satellite receiver,
which includes the following:
• Connecting to your HDTV set or monitor.
• Connecting to your dish antenna and upgrading the software.
• Ordering your programming.
• Setting up to display in HD.
There are two ways to connect this receiver to display high definition
programming quality on an HDTV or HD monitor: using the DVI-HDTV/DISH
DVI connection or the YP
: Your new satellite receiver is factory-set to display in the 480p format at
Note
its HD output connection points.
DVI-HDTV/DISH DVI
This video output port is the preferred method of connecting the receiver to a
DVI-equipped HDTV or HD monitor for best picture quality and simplest
installation.
1. Connect a DVI cable between the DVI-HDTV/DISH DVI connection on the
receiver and the DVI input on your HDTV set or monitor.
2. Connect an RCA A/V cable between the receiver P
O
and the HDTV audio inputs that go with the DVI input on your
UTPUTS
TV or monitor.
3. Turn on your receiver and TV.
4. Consult your HDTV User's Guide, then set your HDTV to display from the
DVI input. Confirm that you are getting a picture from the receiver.
: In most cases connecting the DVI cable will provide plug-and-play
Note
control of the monitor's display resolution and other settings. However,
your HDTV may require selecting a 480p format to display from the
receiver during this installation phase. Consult your HDTV User's Guide.
YPbPr Connections
If your HDTV or HD monitor does not include a DVI input port, you can use
the YP P
component video connections to provide high definition picture
B R
quality to your HDTV or HD monitor. Make the connection using a color-coded
YPbPr cable.
1. Connect video and audio RCA type cables between the receiver RCA A/V
O and corresponding input connections on the HDTV or monitor.
UTPUTS
2. Connect between the YP
the HDTV using component video cables.
3. Power on the TV and receiver using the front panel power button.
4. Consult your HDTV User's Guide, then set your HDTV to display from its
RCA input. Confirm that you are getting a picture from the receiver.
P connections.
B R
P component connections on the receiver and
B R
(RCA) A
HONO UDIO