Table of Contents
Advertisement
The security system will ignore the input that was active when the sys-
tem was armed, until the input goes away. Three seconds later the sys-
tem will monitor that input normally.
1.
If a door is open the siren will chirp 4 times – 5 seconds after
the arming chirps.
2.
If a sensor is active the siren will chirp 4 times – 10 seconds
after the arming chirps.
disarming diagnostics
Extra disarm chirps are the Tamper Alert. If three chirps are heard when
disarming, the system was triggered in your absence. If three chirps are
heard, the LED status indicator will indicate which zone was involved
when you turn the ignition on (see the Table of Zones section). The sys-
tem will retain this information in its memory. Refer to the Multiple
Event Total Recall section of this guide.
arm/disarm diagnostic chart
Action
Chirps
Arm
2
Arm
4
Arm
2 (5 sec.) 4
Arm
2 (10 sec.) 4
Disarm
1
Disarm
3
© 2 0 0 3 d i re c t e d e l e c t ro n i c s , i n c .
Light Flashes
Description
2
System armed
4
System armed with hood/
trunk active and bypassed
(zones 5 and 6)
2 (5 sec.) 4
System armed with door
active and bypassed (zone 4)
2 (10 sec.) 4
System armed with sensor
active and bypassed zones
1, 3, and 8
1
System disarmed
3
System disarmed with
tamper alert
17
Advertisement
Table of Contents
