ScanSoft OMNIPAGE DIRECT 2 FOR WINDOWS Installation Manual page 25

move the mouse. To move the entire zone, move the pointer inside the
zone, hold down the mouse button, and move the mouse.
Order zones
Normally, zones are recognized in the order in which you select them. To
change the order in which the zones will be recognized, click on the Order
zones tool. The numbers in the zones will disappear.
To reorder the zones, click on the zone you want recognized first. The
number 1 will appear in the zone. Then click on the next zone you want
recognized; the number 2 will appear. Continue until the zones are
appropriately ordered.
Erase zones
If you want to de-select a zone, click the Erase zones tool and
then click on the zone you want to deselect. The contents of the
zone will not be removed; only the selection box will go away.
Recognize
Click this button to start recognition.
If you highlighted the Multiple pages icon (and you did not select Pause after
every page in the Options dialog box) the same zones will be recognized on
each page that is scanned. For example, if you select a zone on a form, and
then scan five forms, the same zone will be recognized on each form. If you
selected Pause after every page, you'll be able to draw different zones for
each page.
Cancel
Click this button to stop a scan and return to your application.
Options
Click this button to display the Options dialog box so you can change
settings. All settings are explained in alphabetical order in this chapter.
Adjust
Click this button to change settings after a scan has started but before
recognition is complete. The Recognize button turns into the Adjust
button during recognition.
For example, imagine you selected several zones on a page for recognition
and clicked Recognize. During recognition, you notice that you forgot to
select a particular zone. You click Adjust; recognition stops and you can
select zones correctly or adjust settings without having to re-scan the page.
Partial Page
Commands and Settings 23