ScanSoft OMNIPAGE 15 Manual page 12

◆
Choose 'Select and test scanner or digital camera', then click
Next. If you have a single installed scanner, it appears, along
with any scanners previously set up with OmniPage. If the
required scanner is not listed, click Add Scanner... .
◆
You see a list of all detected scanner drivers in the checkmarked
categories. This can include network devices. Select one and
click OK. To install a second device, you must run the Scanner
Wizard again.
◆
The wizard reports whether the chosen scanner model already
has settings in the scanner database. If it does, you do not need
to test it. If it does not, you should test it. Click on Next.
◆
If you chose not to test, click Finish. If you chose testing, click
Next to have the scanner connection tested. If the connection is
in order, you see a menu of further tests. Choose which testing
steps you want to run. The Basic test scan is recommended.
◆
By default OmniPage uses its own scanning interface, located in
the Scanner panel of the Options dialog box. If you want to use
your scanner's own interface instead, choose Advanced settings...
and select this. Click Hint editor... and choose Edit hints... only
if you are experienced in configuring scanners or have been
advised by Technical Support to do so.
◆
Click Next to start the tests. For the Basic scan test, insert a test
page into your scanner. The wizard will scan using your scanner
manufacturer's software. Click on Next. Your scanner's native
user-interface will appear.
◆
Click on Scan to begin the sample scan.
◆
If necessary, click on Missing Image... or Improper
Orientation... and make the appropriate selections.
◆
Once the image appears correctly in the window, click on Next.
◆
Move through the remaining requested tests, following the
instructions on the screen.
◆
When all the requested tests have been completed successfully,
the Scanner Wizard reports and invites you to click on Finish.
◆
You have successfully configured your scanner to work with
OmniPage 15!
12 Chapter 1