Charge And Discharge Programs; Program Flowchart - GRAUPNER ULTRAMAT 16 Operating Manual

The various facilities of the charger are divided up into four program groups which you can select by
holding the MODE button pressed in for two seconds. The sequence is shown in the flow chart
below.
Ni-Cd battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
Ni-MH battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
LiPo / LiIo / LiFe battery programs: charging, discharging to determine capacity or residual capacity,
or to select cells.
Lead-acid battery programs: charging, discharging to determine capacity or residual capacity, trickle
charge for stand-by operation.
NiCd
MODE
AUTOMATIC-
program
MODE
(2 sec.)
MODE (2 sec.)
NiMH
MODE
AUTOMATIC-
program
MODE
(2 sec.)
MODE (2 sec.)
Lithium
MODE
MANUAL-
program
MODE
MODE (2 sec.)
(2 sec.)
Pb
MODE
MANUAL-
program
MODE
MODE (2 sec.)
(2 sec.)
28

6. Charge and discharge programs

7. Program flowchart

NiCd
MODE
MANUAL-
program
NiMH
MODE
MANUAL-
program
Lithium
MODE
discharge
program
Pb
MODE
discharge
program
NiCd
NiCd
MODE
discharge
program
program
NiMH
MODE
discharge
program program
Lithium
MODE
type
select
NiCd
MODE
discharge balancing
cycle
program
NiCd
MODE
∆ ∆ ∆ ∆ ∆
delta-peak
trigger voltage
NiMH NiMH
MODE
cycle discharge balancing
program
NiMH
MODE
∆ ∆ ∆ ∆ ∆
delta-peak
trigger voltage
MODE
MODE