Charge And Discharge Programs; Program Flowchart - GRAUPNER ULTRA TRIO PLUS 14 Operating Manual

6. Charge and discharge programs (Output 1)
The various facilities of the charger are divided up into four program groups which you can select by
holding the MODE button pressed in for two seconds. The sequence is shown in the flow chart
below.
Ni-Cd battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
Ni-MH battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
LiPo / LiIo / LiFe battery programs: charging, discharging to determine capacity or residual capacity,
or to select cells.
Lead-acid battery programs: charging, discharging to determine capacity or residual capacity, trickle
charge for stand-by operation.
NiCd
MODE
AUTOMATIC-
program
MODE
(2 sec.)
MODE (2 sec.)
NiMH
MODE
AUTOMATIC-
program
MODE
(2 sec.)
MODE (2 sec.)
Lithium
MODE
MANUAL-
program
MODE
MODE (2 sec.)
(2 sec.)
Pb
MODE
MANUAL-
program
MODE
(2 sec.) MODE (2 sec.)
32
7. Program flowchart (Output 1)
NiCd NiCd
MODE
MANUAL- discharge
program
program
NiMH
MODE
MANUAL- discharge
program
Lithium
Lithium
MODE
discharge
program
Pb
MODE
discharge
program
NiCd
MODE
cycle
program
NiMH NiMH
MODE
cycle
program program
Lithium
MODE
storage
program
NiCd
MODE
discharge balancing
program
NiCd
MODE
∆ ∆ ∆ ∆ ∆
delta-peak
trigger voltage
NiMH
MODE
discharge balancing
program
NiMH
MODE
∆ ∆ ∆ ∆ ∆
delta-peak
trigger voltage
MODE
type
select
MODE
MODE