Table of Contents
Advertisement
Toshiba DST-3000 High Definition Digital Receiver
Scan Channels
This option will automatically scan through all of the
possible channel frequencies and place the active
channel numbers into the LOCAL AREA channel list.
NTSC (analog) channels will be listed by the Channel
Number followed by a hyphen and the number zero. An
example would be 2-0. At this time, the program
information for local NTSC and ATSC digital channels
that is shown on the Advanced Program Guide™ will
simply display "Regular Schedule." To receive accurate
program information for these channels, you need to
select a local provider on the DISH SETUP screen.
Channel Scan
Editing Local Channels
To remove or add local NTSC analog and ATSC digital channels in the channel list, use the and
L
L
keys to highlight the specific channel. Press
to remove the checkmark and the channel
SELECT
from the channel list. Press
again to add it back.
SELECT
Time Setup
The TIME SETUP screen allows you to set your time
zone and whether or not you observe daylight savings
time. If you have selected a DISH TYPE of "None,"
buttons allowing you to set the current date and time
will also appear.
L
Use the
and
L
buttons to move around the TIME
SETUP screen, then press SELECT to select an item,
and you can use your remote control to enter numbers.
Installation Is Now
Time Setup screen
Complete
The installation and testing of the satellite dish antenna and/or terrestrial inputs is now complete.
You are ready to enjoy your system.
Page 4-10
Advertisement
Table of Contents
