Hd Receiver And Standard Stereo System; Finishing Up - Toshiba DST-3000 Owner's Manual

HD Receiver and Standard Stereo System

Follow these steps indicated by the diagram below:
1) Connect a set of stereo audio cables (one white left connector and one red right connec-
tor) to the back of the HD receiver using the connectors marked AUDIO L, R. Connect
the other ends of the cables to the back of your stereo system using a set of AUDIO
inputs. You may select any input except for the input marked PHONO, TT, or TURN-
TABLE. Those inputs are for turntables only and will distort the sound from any other
components.
Note: If you used both sets of connectors marked VIDEO and AUDIO L, R in
connecting your TV or VCR you will have to replace one set of the AUDIO L,
R connections as shown below.

Finishing Up

You can mix and match the different hookups described herein to suit your entertainment
system's available connections. For example, you can connect the VCR using audio/video cables,
while the TV is connected with the coaxial RF cable. Always try to achieve the highest quality
audio and video and greatest flexibility possible.
Once all connections have been completed, connect the TV, VCR, and DST-3000 receiver to the
wall power outlet, appropriate extension cord, or surge protector.
Note: A surge protector is recommended to reduce the chance of receiver
damage due to electrical surges on the power line.
Setting Up Your Satellite Receiver
Page 2-13