Table of Contents
Advertisement
1. F F u u s s e e . . Remove and re-insert fuse into main fuse holder.
note: If the WHITE (H1/9) wire at the control module
is not cut the doors will lock 3-seconds after turning the
ignition on.
3. P P r r o o g g r r a a m m . . Within 10-seconds, press and hold the
button on the transmitter, until the parking lights turn off
and then back on. Now release the
this step within 10-seconds of programming a transmitter to
program additional transmitters to your system.
note: To ensure proper system operation, use the trans-
mitter at a distance of greater than 18 inches from the
control module.
4. E E x x i i t t L L e e a a r r n n M M o o d d e e . . After programming the transmitter, wait
10-seconds, the parking lights will turn off. Programming
transmitter(s) is now complete.
32
2. K K e e y y . . Turn the ignition to the ON position.
The parking lights will immediately turn on to
indicate transmitter learn mode. After 5-
seconds the parking lights will turn off and then
turn back on to indicate ready to learn mode.
button. Repeat
© 2006 directed electronics.
Advertisement
Table of Contents
