Install Anti-Tip Bracket - KitchenAid Architect Series II KDRS505XSS Installation Instructions Manual

1. Remove the anti-tip bracket that is taped inside the upper
oven with the package containing literature.
2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor you can use the wall
mounting method.
3. Determine and mark edge of range in the cutout space. The
mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout so
that right (or left) edge of the bracket is
marked edge of the range, as shown.
B
A. Anti-tip bracket
B. Mark edge of range.
C. " (2.4 cm)
4. Drill two " (3.0 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following.
10

Install Anti-Tip Bracket

" (2.4 cm) from the
A
C
Floor Mounting
A. #12 x 1 " screws
B. Anti-tip bracket
Wall Mounting
A
A. #12 x 1 " screws
B. Anti-tip bracket
5. Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1 " screws provided.
A
B
B