Panic Mode - Directed Electronics Viper 211HV Owner's Manual

To enter or exit Valet
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet®
switch within 10 seconds.
The status LED will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet
➜

panic mode

If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter. Just
press for two seconds to enter Panic Mode. In Panic Mode,
the horn will honk and the parking lights will flash for 30
seconds. To stop Panic Mode at any time, press
transmitter again.
note: In order for Panic Mode to be effective, the vehicle's
horn (or optional siren) as well as the vehicle's parking
lights must be connected.
r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
This Directed system will store its current state to non-volatile
memory. If power is lost and then reconnected, the system will
recall the stored state from memory. This means if the unit is in
© 2005 directed electronics, inc.
® Mode:
DRW-35
®
® Mode.
on the
11