Directed Electronics Clifford 2.2 Owner's Manual
  1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Car Alarm
  5. Clifford 2.2
  6. Owner's manual
Directed Electronics Clifford 2.2 Owner's Manual

Directed Electronics Clifford 2.2 Owner's Manual

Directed electronics 2.2 security and remote start owner's guide
Hide thumbs Also See for Clifford 2.2:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Installation Manual
Model 2.2
Security and Remote Start
Owner's Guide
© 2008 Directed Electronics, Vista, CA
G5102X 2008-06

Advertisement

Table of Contents
loading

Related Manuals for Directed Electronics Clifford 2.2

Summary of Contents for Directed Electronics Clifford 2.2

  • Page 1 Model 2.2 Security and Remote Start Owner’s Guide © 2008 Directed Electronics, Vista, CA G5102X 2008-06...

  • Page 3: Table Of Contents

    Contents Government regulations ...5 Warning! Safety first ...7 What is included ...10 Important information ...10 Your warranty...10 Replacement remotes...11 System maintenance ...11 Low battery indicator ...11 Battery Replacement ...11 Two Car Operation ...11 1-way remote ...13 Transmitter configuration ...14 Feature List: ...15 Using the system ...18 Arming the system...18 While the system is armed ...18...
  • Page 4 Programming options ...39 Security & convenience expansions ...41 Glossary of terms ...43 Quick reference guide ...45 Notes ...47 Limited lifetime consumer warranty ...49...

  • Page 5: Government Regulations

    This device complies with the Industry Canada Radio Standards Specification © 2008 Directed Electronics. All rights reserved.
  • Page 6 WARNING! Changes or modifications not expressly approved by the party re- sponsible for compliance could void the user’s authority to operate this device. © 2008 Directed Electronics. All rights reserved.

  • Page 7: Warning! Safety First

    Leave the vehicle in neutral and be sure no one is standing in front or behind the vehicle. • Only remote start on a flat surface • Have the parking brake fully engaged © 2008 Directed Electronics. All rights reserved. because you must leave your car in neutral. You...
  • Page 8 CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AU- THORIZED Directed DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. DIRECTED WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS. © 2008 Directed Electronics. All rights reserved.
  • Page 9 This product should not be installed in any convertible vehicles, soft or hard top with a manual transmission. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics. All rights reserved.

  • Page 10: What Is Included

    Make sure you receive the warranty registration from your dealer. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. © 2008 Directed Electronics. All rights reserved.

  • Page 11: Replacement Remotes

    Place the new battery into the remote control. When power is returned the remote control is ready for use. ➤ Two Car Operation You can use the remote control system for two cars with full command capability for both vehicles. © 2008 Directed Electronics. All rights reserved.
  • Page 12 To scroll from one car to the other press the selecting the car, operation of other features can resume. The se- lected car remains selected until this setting is changed. button until the amber light blinks once or button again. After © 2008 Directed Electronics. All rights reserved.

  • Page 13: 1-Way Remote

    Label Battery Door Note: If Keypad Lock is On, press © 2008 Directed Electronics. All rights reserved. Press for one second to arm. Press for one second to disarm. Press for one second to activate remote start. Press and hold for 1.5 second to activate trunk release.

  • Page 14: Transmitter Configuration

    Valet On/ Car Finder Timer Mode Smart Start On/Off On/Off AUX 2 AUX 3 Runtime Event His- Remaining tory Report * † * † held to access state © 2008 Directed Electronics. All rights reserved. Silent Alarm All Zones † Defogger...

  • Page 15: Feature List

    Command Press one- time and then press Notes Arms the system without chirps Silent disarm Command Press one- time and then press Notes Disarms the system without chirps © 2008 Directed Electronics. All rights reserved. open Trunk A U X...
  • Page 16 Send again to bypass Warn & Full Trigger; Send again to turn bypass off and monitor sensors normally. For more information, see Modified Arming Modes. Valet mode Command Press two-times and then A U X © 2008 Directed Electronics. All rights reserved.
  • Page 17 55˚ F the defogger will not activate. Panic Command Press and hold Notes The siren will trigger until you hit the lock or unlock button on the remote © 2008 Directed Electronics. All rights reserved. . (Only after remote for 1.5 seconds. A U X...

  • Page 18: Using The System

    The system will arm without the confirmation chirp. The parking lights will flash once. ➤ While the system is armed A U X • Fail-Safe Starter Kill The starter is disabled by the system’s Fail-Safe starter kill (if installed). © 2008 Directed Electronics. All rights reserved.
  • Page 19 Opening a door: the Progressive Door Trigger feature will first sound the Warn-Away response, followed immediately by Full Alarm. • An optional sensor, such as an optional Proximity Sensor triggered in the inner zone. © 2008 Directed Electronics. All rights reserved.

  • Page 20: Modified Arming Modes

    Warn-Away response or the Full Alarm response. After disabling Warn-away response, press the twice. Press the button. Note: The next time you arm the system, the shock sensor will work normally. A U X the button © 2008 Directed Electronics. All rights reserved.

  • Page 21: Disarming The System

    The door locks (if connected) will unlock, and the parking lights will flash. While the alarm is triggering: Press the button on the remote. The siren will stop sounding and disarm the alarm system. © 2008 Directed Electronics. All rights reserved.

  • Page 22: System Override

    Override Switch Number ___________ ➤ Valet mode To enter or exit valet mode with the valet/program switch: Turn the ignition key on and then off. © 2008 Directed Electronics. All rights reserved.

  • Page 23: Remote Feature Programming

    When the remote beeps once the keypad automatically locks 6o seconds after the last button operation to avoid accidental A U X © 2008 Directed Electronics. All rights reserved. to put the system into/out of Valet button on the remote for 12 seconds. (ig-...
  • Page 24 A U X , and then press button is pressed, the keypad auto lock A U X © 2008 Directed Electronics. All rights reserved. to unlock the for 2 seconds, A U X...

  • Page 25: Using The Remote Start

    • When the brake pedal is pressed • The hood is opened • If the alarm is triggered when armed. • When the Remote Start command is sent again from a remote control. © 2008 Directed Electronics. All rights reserved.

  • Page 26: Manual Transmission Vehicles

    To drive your vehicle after it has been remote started: Get in without stepping on the brake. Insert the ignition key and turn it to the ON position. Now, step on the brake. Note: Pressing the brake again © 2008 Directed Electronics. All rights reserved.

  • Page 27: Timer Mode

    4 times when exiting timer mode. The same procedure may be used to enter or exit Timer Mode using the remote transmitter. © 2008 Directed Electronics. All rights reserved. twice and then press . Parking lights flash slowly four...

  • Page 28: Turbo Timer Mode

    . After exiting the vehicle, lock the © 2008 Directed Electronics. All rights reserved.

  • Page 29: Smart Start

    3 times and then press the button. The parking lights flash 5 times fast to confirm the remote is in Smart Start mode. To activate Smart Start mode with a manual transmission: Enter the MTS procedure. © 2008 Directed Electronics. All rights reserved.

  • Page 30: Turning On The Rear Defogger

    To manually activate the rear defogger after remote start is on: • Press four times, and then press times to confirm the defogger activation. button on the remote (the vehicle A U X . The parking lights flash 4 © 2008 Directed Electronics. All rights reserved.

  • Page 31: Valet Take-Over

    If the vehicle shuts down when locking, then the unit did not enter valet take-over mode. © 2008 Directed Electronics. All rights reserved. on the trans-...

  • Page 32: Safety Features

    To disable the remote start, move the shutdown toggle switch to the OFF position. Check with your installer for the location. Location of Shutdown Switch____________________________ © 2008 Directed Electronics. All rights reserved.

  • Page 33: Diagnostics

    Once the light turns off, however, the security system resumes normal monitoring. Note: Bypass Notification does not occur when the system is in Silent Mode or if the notification chirps have been programmed off by the installer. © 2008 Directed Electronics. All rights reserved.

  • Page 34: Disarming

    Description System armed System armed with bypass notification System disarmed System disarmed with Tamper Alert System disarmed, NPC activated © 2008 Directed Electronics. All rights reserved.

  • Page 35: Interpreting Zone Diagnostics

    For example: If the alarm triggers three times within a 60-minute period and each time the same sensor or switch triggers the alarm, NPC will © 2008 Directed Electronics. All rights reserved. Dealer installed options...
  • Page 36 NPC to bypass a faulty zone. When disarming the system, 5 chirps indicate NPC is activated. The LED reports the zone that has been bypassed. (See Diagnostics section of this guide.) © 2008 Directed Electronics. All rights reserved.

  • Page 37: Owner Recognition

    Valet Mode. This applies to all states of the system including arm, disarm, and Valet Mode. © 2008 Directed Electronics. All rights reserved.

  • Page 38: Power Saver Mode

    Valet Mode, the status LED will shut off. If the system remains in Valet Mode, the LED will come back on the next time the ignition is turned on and then back off. © 2008 Directed Electronics. All rights reserved.

  • Page 39: Programming Options

    Full trigger response 30 or 60 seconds: • the full triggered sequence lasts. Some states have laws regulating © 2008 Directed Electronics. All rights reserved. with or without Warn-away chirps, or OFF: When this fea- /disabled when the ignition is turned on or...
  • Page 40 The chirps can be either full volume or 6 decibels quieter than the full alarm blast. Comfort closure • is a programming option which closes the ve- hicle’s windows after remote locking. The output of the Revenger™Soft © 2008 Directed Electronics. All rights reserved.

  • Page 41: Security & Convenience Expansions

    Although the on-board relay can control most power trunk releases, sometimes an optional relay is required. If the factory release is not power-activated, Directed®’s 522T trunk release solenoid can often be added. © 2008 Directed Electronics. All rights reserved.
  • Page 42 Power Window Control: Automatic power window control is provided with the 529T and 530T systems. These can operate power windows, and can roll them up automatically when the system is armed, roll them down, or both up and down. Ultrasonic Cabin Sensor: Using the 509U Ultrasonic cabin sensor pro- vides a field of protection inside the car to protect your belongings.

  • Page 43: Glossary Of Terms

    Trigger or Triggered Sequence: This is what happens when the alarm “goes off ” or “trips.” The triggered sequence of your system consists © 2008 Directed Electronics. All rights reserved.
  • Page 44 of the siren sounding and parking lights flashing for the programmed duration. Valet Button: A small push button switch located on your systems control center. It is used to override the starter interrupt when a 2-way remote is lost or damaged, or to enter or exit Valet Mode. Warn Away®...

  • Page 45: Quick Reference Guide

    Number of Valet button pulses for disarming_______________ Silent Arm Press one time and then press Silent Disarm Press one time and then press Remote Start Press Rear Defogger © 2008 Directed Electronics. All rights reserved. on your remote while the A U X A U X...
  • Page 46 Then wait a few seconds. Turn the ignition key to the OFF position. The engine will remain running until the programmed time elapses or a shut-down input is received. Location of Valet button_________________________________ © 2008 Directed Electronics. All rights reserved.

  • Page 47: Notes

    Notes © 2008 Directed Electronics. All rights reserved.
  • Page 48 © 2008 Directed Electronics. All rights reserved.

  • Page 49: Limited Lifetime Consumer Warranty

    Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote transmitters, the associated...
  • Page 50 Authorized dealer’s company name and address Type of alarm installed Year, make, model and color of the automobile Automobile license number Vehicle identification number All security options installed on automobile Installation receipts © 2008 Directed Electronics. All rights reserved. 920-0003 06-06...
  • Page 52 The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology.

Table of Contents