How Tacacs+ Authentication Works; Tacacs+ Authentication Features; Authorization - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Application Manual

TACACS+ offers full packet encryption whereas RADIUS offers password-only encryption in authentication
requests.
TACACS+ separates authentication, authorization, and accounting.

How TACACS+ authentication works

TACACS+ works much in the same way as RADIUS authentication.
1. Remote administrator connects to the switch and provides user name and password.
NOTE: The user name and password can have a maximum length of 128 characters. The password
cannot be left blank.
2. Using Authentication/Authorization protocol, the switch sends request to authentication server.
3. Authentication server checks the request against the user ID database.
4. Using TACACS+ protocol, the authentication server instructs the switch to grant or deny administrative access.
During a session, if additional authorization checking is needed, the switch checks with a TACACS+ server to
determine if the user is granted permission to use a particular command.

TACACS+ authentication features

Authentication is the action of determining the identity of a user, and is generally done when the user first attempts to
log in to a device or gain access to its services. Switch software supports ASCII inbound login to the device. PAP,
CHAP and ARAP login methods, TACACS+ change password requests, and one-time password authentication are not
supported.

Authorization

Authorization is the action of determining a user's privileges on the device, and usually takes place after
authentication.
The default mapping between TACACS+ authorization privilege levels and switch management access levels is
shown in the table below. The privilege levels listed in the following table must be defined on the TACACS+ server.
Table 4 Default TACACS+ privilege levels
User access level
user
oper
admin
Alternate mapping between TACACS+ privilege levels and GbE2c management access levels is shown in the table
below. Use the command /cfg/sys/tacacs/cmap ena to use the alternate TACACS+ privilege levels.
Table 5 Alternate TACACS+ privilege levels
User access level
user
oper
admin
You can customize the mapping between TACACS+ privilege levels and GbE2c management access levels. Use the
command /cfg/sys/tacacs/usermap to manually map each TACACS+ privilege level (0-15) to a corresponding
GbE2c management access level (user, oper, admin, none).
If the remote user is authenticated by the authentication server, the GbE2c verifies the privileges of the remote user
and authorizes the appropriate access. When both the primary and secondary authentication servers are not
reachable, the administrator has an option to allow backdoor access via the console only or console and Telnet
access. The default value is disable for Telnet access and enable for console access. The administrator also can
enable secure backdoor (/cfg/sys/tacacs/secbd) to allow access if both the primary and secondary TACACS+
servers fail to respond.
TACACS+ level
0
3
6
TACACS+ level
0—1
6— 8
14—15
Accessing the switch 22