HP GbE2c - Blc Layer 2/3 Fiber SFP Option Application Manual page 46
Ethernet blade switch for c-class bladesystem
Hide thumbs
Also See for GbE2c - Blc Layer 2/3 Fiber SFP Option:
- Interface manual (209 pages) ,
- Command reference manual (175 pages) ,
- Cli reference manual (153 pages)
Table of Contents
Advertisement
Figure 5
802.1Q tagging (after port-based VLAN assignment)
In the following figure, the tagged incoming packet is assigned directly to VLAN 2 because of the tag assignment in
the packet. Port 5 is configured as a tagged member of VLAN 2, and port 7 is configured as an untagged member of
VLAN 2.
Figure 6
802.1Q tag assignment
As shown in the following figure, the tagged packet remains unchanged as it leaves the switch through port 5, which
is configured as a tagged member of VLAN 2. However, the tagged packet is stripped (untagged) as it leaves the
switch through port 7, which is configured as an untagged member of VLAN 2.
Figure 7
802.1Q tagging (after 802.1Q tag assignment)
NOTE:
Using the /boot/conf factory command resets all ports to VLAN 1 (except port 19) and all other
settings to the factory defaults at the next reboot.
VLANs 46
Advertisement
Table of Contents
Troubleshooting
