Label - Konica Minolta bizhub C25 User Manual

Use envelopes that are
- Common office envelopes approved for laser printing with diagonal
joints, sharp folds and edges, and ordinary gummed flaps
d
- Approved for laser printing
- Dry
DO NOT use envelopes that have
- Sticky flaps
- Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for
sealing
- Transparent windows
- Too rough of a surface
- Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
- Been presealed

Label

A sheet of labels consists of a face sheet (the printing surface), adhesive,
and a carrier sheet:
- The face sheet must follow the plain paper specification.
- The face sheet surface must cover the entire carrier sheet, and no adhe-
sive should come through on the surface.
You can print continuously with label sheets. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Try printing your data on a sheet of plain paper first to check placement.
Check your application documentation for more information on printing
labels.
Capacity
Orientation Tray 1
Driver
Media Type
3-6
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
Tray 1/2
Tray 3
Tray 2
[Label]
Up to 20 sheets, depending on their thick-
ness
Not supported
Face down
Face up
Media