Main Power Wall Switch Wiring For 120 Volt - Dimplex BF33ST/DX Installation Manual

NOTE:
This option should not be used with the remote control kit.
NOTE:
Before installing the unit have the following wires installed:
1. A 2 conductor wire with ground (3 wires total) from the power supply panel to the
main switch wall box.
2. A 2 conductor wire with ground (3 wires total) from the main switch wall box to the
junction box on the unit.
NOTE:
Use a single pole, single throw (on/off) wall switch that is rated for a minimum of 15 amps.
120 VOLT INSTALLATIONS
1. Locate the voltage selector switch inside the exhaust panel on the top right hand corner
of the unit. (see figure 2 on page 3)
2. Ensure that the switch is in the 120 volt position. (115 is printed on switch)
3. Loosen the screw securing the junction box cover and remove the cover.
4. Remove the knockouts (if necessary) or use the provided cable clamp.
5. Pull out the four wires marked L1, L2, N, and G. (black, red, white and green)
6. Connect the (black) L1 wire from the unit to the (black) L1 wire from the main power wall
switch using a wire connector (not supplied).
7. Connect the other end of the (black) L1 wire to the L1 terminal of the main power wall
switch.
8. Connect the (red) L2 wire from the unit and the (white) Neutral wire from the unit to the
(white) Neutral wire of the main power wall switch by using a wire connector (not
supplied).
9. Connect the other end of the (white) Neutral wire to the (white) Neutral wire from the
power supply panel by using a wire connector (not supplied).
10. Connect the (green) Ground wire from the unit to the (green) Ground wire of the main
power wall switch by using a wire connector (not supplied).
11. Connect the (black) L1 wire from the power supply to the L1 terminal of the main power
wall switch.
12. Secure the 2 remaining (green) Ground wires with a ground screw in the main switch
wall box.
13. Ensure that all connections are tight.
14. Insert all the wiring of the main power wall switch into the main switch wall box.
15. Insert all the wiring back into the unit and secure with a cable clamp.
MAIN POWER WALL SWITCH WIRING
FOR 120 VOLT
9