To Replace Main On/Off Switch - Dimplex OPTIFLAME BF Series Parts & Service Manual

OPTIFLAME ELECTRIC FIREPLACE
If the fireplace was operating prior to servicing allow at least 10 minutes for light
bulbs and heating elements to cool off to avoid accidental burning of skin.
Disconnect circuit power before attempting any maintenance or cleaning to
reduce the risk of electric shock or damage to persons.

TO REPLACE MAIN ON/OFF SWITCH

1. Open the steel curtains (remove glass doors if applicable).
2. Remove the log grate retaining screws and remove the log grate.
3. Pull the rear edge of the log set forward by grasping the ember bed by the
sides (handle the log set only by the ember bed and not the logs) and
pulling firmly until the rear tab pops out from under the back ledge, then lift
out.
4. Remove the light bulb closest to the main on/off switch for easier access.
5. Locate the cover plate by the switches and remove the mounting screws.
6. Remove the cover plate.
7. Reach hand into the opening and locate the main on/off switch.
8. Depress the retainer clips on the rear of the switch and push the switch
out of the bottom cover.
NOTE: It may be necessary to remove the heater on/off switch as well for
easier access.
9. Disconnect the wiring connections noting their original locations.
10. Properly orient the new switch and connect all of the wiring connections.
11. Reassemble in the reverse order as above.
OPTIFLAME ELECTRIC FIREPLACE
10