D-Link DIR-827 User Manual page 47

Section 3 - Software Configuration
Static.IPv6.Address.Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information is manually entered in your
IPv6 configuration settings. You must enter the IPv6 address, Subnet Prefix Length, Default Gateway, Primary DNS Server, and Secondary DNS
Server. Your ISP provides you with all this information.
Use.Link-Local.
The Link-local address is used by nodes and routers when communicating
Address:
with neighboring nodes on the same link. This mode enables IPv6-
capable devices to communicate with each other on the LAN side.
IPv6.Address:
Enter the WAN IPv6 address for the router here.
Subnet.Prefix.
Enter the WAN subnet prefix length value used here.
Length:
Default.Gateway: Enter the WAN default gateway IPv6 address used here.
Primary.IPv6.DNS. Enter the WAN primary DNS Server address used here.
Address:
Secondary.IPv6.DNS. Enter the WAN secondary DNS Server address used here.
Address:
LAN.IPv6.Address: These are the settings of the LAN (Local Area Network) IPv6 interface for the router. The router's LAN IPv6 Address configuration is based on the IPv6
Address and Subnet assigned by your ISP. (A subnet with prefix /64 is supported in LAN.)
Click on the Next button to continue. Click on the Prev button to return to the previous page.
Click on the Cancel button to discard all the changes made and return to the main page.
D-Link DIR-827 User Manual 42