Verifying The Idsm-2 Installation - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 8 Installing the IDSM-2
Step 12
Step 13
Step 14
Step 15

Verifying the IDSM-2 Installation

Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Configure the switch for command and control access to the IDSM-2.
See Configuring the Catalyst 6500 Series Switch for Command and Control
Access to the IDSM-2, page
Upgrade your IDSM-2 to the most recent Cisco IDS software.
See Obtaining Cisco IDS Software, page
Assign the interfaces.
See Assigning and Enabling the Sensing Interface, page
See Using the TCP Reset Interface, page
interface.
Set up the IDSM-2 to capture IDS traffic.
See Copying IDS Traffic, page
You are now ready to configure the IDSM-2 for intrusion detection.
Verify that the switch acknowledges the new IDSM-2 and has brought it online.
To verify the installation, follow these steps:
Log in to the console.
For Catalyst software, verify that the IDSM-2 is online by typing the following:
cat6k> enable
console> (enable) show module
Mod Slot Ports Module-Type
--- ---- ----- ----------------------- ----------------- --- -----
1 1 2 1000BaseX Supervisor
15 1 1 Multilayer Switch Featu WS-F6K-MSFC2
2 2 48 10/100BaseTX Ethernet
3 3 2 Intrusion Detection Sys WS-X6381-IDS
4 4 8 1000BaseX Ethernet
5 5 2 Intrusion Detection Sys WS-X6381-IDS
6 6 0 FlexWAN Module
7 7 2 Intrusion Detection Sys WS-x6381-IDS
9 9 8 Intrusion Detection Sys WS-SVC-IDSM2
Mod Module-Name
Installation and Removal Instructions
10-88.
9-1, for the procedure.
8-4, for information on the TCP reset
10-90, for the procedure.
Model
WS-X6K-SUP2-2GE
WS-X6548-RJ-45
WS-X6408-GBIC
WS-X6182-2PA
Serial-Num
10-9, for the procedure.
Sub Status
yes ok
no ok
no ok
no faulty
no ok
no ok
no ok
no ok
yes ok
8-11