Table of Contents
Advertisement
Chapter 10
Configuring the Sensor Using the CLI
Step 3
Displaying Tech Support Information
Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Warning: Executing this command will stop all applications and
reboot the node. Continue with reset?:
Type yes to continue the reset.
b.
The appliance reboots.
To stop all applications and power down the appliance, follow these steps:
a.
Power down the appliance:
sensor# reset powerdown
A warning appears:
Warning: Executing this command will stop all applications and
reboot the node if possible. If the node cannot be powered off, it
will be left in a state that is safe to manually power down.
Continue with reset?:
b.
Type yes to continue the reset.
Broadcast message from root (Sat May 15 05:25:09 1993):
A system reboot has been requested. The reboot may not start for
90 seconds.
Request Succeeded.
sensor#
Broadcast message from root (Sat May 15 05:25:12 1993):
The system is going down for reboot NOW!
You are prompted to turn off the power switch on the appliance.
You can display system information on the screen or have it sent to a specific URL
to use as a troubleshooting tool with TAC.
To display tech support information, follow these steps:
Log in to the CLI using an account with administrator privileges.
View the optional parameters for the show tech-support command:
sensor# show tech-support ?
Sensor Administrative Tasks
10-31
Advertisement
Table of Contents
Troubleshooting
