Table of Contents
Advertisement
Modifying PPTP Server Design
Step 1. Select VPN > PPTP Server.
Step 2. Click Modify after the Client IP Range.
Step 3.
In the Modify Server Design
!
Disable PPTP- Check to disable PPTP Server.
!
Enable PPTP- Check to enable PPTP Server.
!
Auto-Disconnect if idle ... minutes- Configure this device
to disconnect to the PPTP Server when there is no activity for
a predetermined period of time. To keep the line always
connected, set the number to 0.
!
Schedule- Click the down arrow to select the schedule,
which was pre-determined in Schedule. Refer to the
corresponding section for details
Step 4.
Click OK to save modifications or click Cancel to cancel modifica-
tions
86
1. Encyption: the default is set to disabled.
2. Client IP Range Enter the IP range allocated for PPTP
Client to connect to the PPTP server.
Window, enter appropriate settings.
.
Advertisement
Table of Contents
