D-Link DFL-80 User Manual page 72

Adding an Incoming Policy:
Step 1: Under Incoming of the Policy menu, click the New Entry button.
Step 2:
Source Address: Select names of the external networks from the drop down
list. The drop down list contains the names of all external networks defined in
the External section of the Address menu. To create a new source address,
please go to the Internal section under the Address menu.
Destination Address: Select names of the internal networks from the drop
down list. The drop down list contains the names of IP mapping addresses
specified in the Mapped IP or the Virtual Server sections of Virtual Server
menu. To create a new destination address, please go to the Virtual Server
menu. (Please refer to Chapter 8 for Virtual Server for details)
Service: Specified services provided by internal network servers. These are
services/application that are allowed to pass from the External network to the
Internal network. Choose ANY for all services.
Action: Select Permit or Deny from the drop down list to allow or reject the
packets travelling between the specified external network and Virtual Server/
Mapped IP.
Logging: Select "Enable" to enable flow monitoring.
Statistics: Select "Enable" to enable flow statistics.
Alarm Threshold: Set a maximum flow rate (in Kbytes/Sec). An alert will be
sent if flow rates are higher than the specified value.
Step 3: Click OK to add new policy or click Cancel to cancel adding new
incoming policy.
72