Leds; Physical Connections - D-Link DFL-700 - Security Appliance Product Manual

LEDs

Power: A solid light indicates a proper connection to the power supply.
Status: A System status indicator that flashes occasionally to indicate a functional, active
system. Solid illumination of the Status LED indicates a hardware/software critical failure.
WAN, LAN, & DMZ: Bright Green illumination indicates a valid Ethernet Link on that
respective port. Each LED will flicker when that respective port is sending or receiving
data.

Physical Connections

COM Port: Serial Read-Only access to the firewall software from a PC equipped with a
Serial COM port (9600 baud, 8 data bits, No Parity, 1 Stop bit, No Flow Control).
LAN Port: Use this port to connect to a Fast Ethernet Switch to service more than 1 client
PC on the internal office network.
DMZ Port: Use this port to service an additional physically segmented Private or
Transparent Network to be occupied by WAN accessible servers (FTP, HTTP, DNS).
WAN Port: Use this port to connect to an external network, such as a WAN or a modem
provided by an ISP.
Reset: Use this switch to reset the DFL-700 to factory default settings. Refer to page 67
for further instructions.
DC Power: Use the included 5VDC 3A switching power supply to connect to an
110/120VAC electrical receptacle. Do not use less than 5VDC 3A to power the device,
doing so will damage the unit.