Adding An L2Tp/Pptp Vpn Client; Adding An L2Tp/Pptp Vpn Server - D-Link DFL-700 - Security Appliance Product Manual

Adding an L2TP/PPTP VPN Client

Follow these steps to add an L2TP or PPTP VPN Client configuration.
Step 1. Go to Firewall and VPN and choose Add new PPTP client or Add new L2TP
client in the L2TP/PPTP Clients section.
Step 2. Enter a Name for the new tunnel in the name field. The name can contain
numbers (0-9) and upper and lower case letters (A-Z, a-z), and the special characters '-
' and '_'. No other special characters or spaces are allowed.
Step 3. Enter the username and password for the PPTP or L2TP Client.
Step 4. Specify if the IP should be received from the server or if a static one should be
used. This field should be left blank in most scenarios.
Step 5. Specify the Remote Gateway; this should be the IP of the L2TP or PPTP Server
you are connecting to.
Step 6. If you are using IPSec encryption for the L2TP or PPTP Client, choose the
appropriate authentication type, either PSK (Pre-shared Key) or Certificate-based.
Click the Apply button below to apply the change or click Cancel to discard changes.

Adding an L2TP/PPTP VPN Server

Follow these steps to add an L2TP or PPTP VPN Server configuration that listens on the
WAN IP.
Step 1. Go to Firewall and VPN and choose Add new PPTP server or Add new L2TP
server in the L2TP/PPTP Server section.
Step 2. Enter a Name for this tunnel in the name field. The name can contain numbers (0-
9) and upper and lower case letters (A-Z, a-z), and the special characters '–' and '_'. No
other special characters or spaces are allowed.
Step 3. Specify the Client IP Pool; this should be a range of unused IP's on the LAN
interface that will be handed out to L2TP or PPTP Clients.
Step 4. If you are using IPSec encryption for the L2TP or PPTP Client choose
authentication type, either PSK (Pre-shared Key) or Certificate-based.
Click the Apply button below to apply the change or click Cancel to discard changes.