Tuning To A Station; Entering Stations Into Memory Automatically (The Automatic Preset Mode: Asm) - Eclipse CD8445E Owner's Manual

Operation

Tuning to a station

First, press the [FM AM] button to start tuner
operation.
There are automatic and manual methods for
setting stations in memory. The receiver will
accept up to 30 stations in memory: 6 in AM
(MW), 6 in LW and 18 in FM (6 each for FM1,
FM2 and FM3.) (Initial setting)
Press the [FM AM] button for less
1
than one second to switch to the
desired FM, AM (MW) and LW
bands.
Radio bands will switch from FM1 ➔
FM2 ➔ FM3 ➔ AM (MW) ➔ LW in
order each time the button is
pressed.
Turn the [SEL] button to the left or
2
right to tune to a station.
Turn to the right:
Tunes to higher frequencies.
Turn to the left:
Tunes to lower frequencies.
Press the [
3
start the automatic
button:
[ ]
Starts searching toward higher
frequencies.
button:
[ ]
Starts searching toward lower
frequencies.
] or [ ] button to
station
ATTENTION
At times, it may be difficult to maintain
optimum reception because the antenna
affixed to your vehicle is in motion
constantly (relative to the broadcast
antenna),
variation in the received radio signals'
strength. Other factors affecting reception
include
obstacles, sign posts, etc.
Entering stations into
memory automatically
(The automatic preset mode:
ASM)
Press the [FM AM] button for less
1
than one second.
You can switch the mode to
desired one.
Press the [SEL] button for more
2
than two seconds until a beep is
heard.
The automatic preset mode starts.
The [ASM ON] indicator on the
screen flashes, and stations are
automatically entered in memory
under buttons [1] to [6].
These buttons are called preset
buttons.
ATTENTION
• Pressing the preset buttons ([1] to
[6]) allows you to make one-touch
station selections. The frequency
of the selected station is indicated
on.
• When a new station is set in
memory, the station previously set
in memory will be deleted.
150
encountering continuous
interference from natural