Flashing Led On The Control Panel; Erroneous Temperature On The Display - Dimension One Spas 01513-192 Owner's Manual

Flashing LED on the Control Panel

E roneous Temperature on the Display r
28
Aquatic Fitness System
2005 Owner's Manual
DO NOT ENTER THE WATER if you see 3 flashing LEDs on the
Digital Display Control. The system has detected a problem.
If you have flashing lights, but the LED Digital Display Window
shows the current water temperature, you have a water flow
problem. You will need to check the water level and/or clean
the filters.
Before checking the water level or cleaning
the filter be sure to test the water
temperature. Do not rely exclusively on the
accuracy of the temperature reading in the
LED Digital Display Window. Make sure the
water temperature is safe before cleaning
the filters.
The flashing lights should stop once the problem is fixed. If the
problem persists, reset the power to the spa by resetting the
GFCI breaker.
If the error is not resolved after resetting the spa, contact your
local Authorized Dimension One Spas Dealer, or authorized
service center.
DO NOT ENTER THE WATER if you see a temperature
reading of 32° F (≅0° C) or 136° F (≅57.8° C) without first
checking the actual water temperature with a separate
thermometer. The system has detected a Temperature
Probe Failure and the water may be too hot, or too cold, to
safely use.
Contact your local Authorized Dimension One Spas Dealer, or
authorized service center.