Auto Cook Mode - Crock-Pot SMART-SET Manual

Auto Cook Mode

The Auto Cook Mode automatically times and cooks your meal using a The Auto Cook Mode automatically times and cooks your meal using a
temperature probe. The pre-set meat options and digital thermometer temperature probe. The pre-set meat options and digital thermometer
ensure perfect results, regardless of variables that can effect cook time such ensure perfect results, regardless of variables that can effect cook time such
as unit starting temperature, fresh or frozen food, food size or ingredients. as unit starting temperature, fresh or frozen food, food size or ingredients.
Smart-Set™ slow cooker automatically switches to the WARM setting when Smart-Set™ slow cooker automatically switches to the WARM setting when
cooking is done so that your meal stays WARM cooking is done so that your meal stays
mode when taste is your top concern, as it was designed to produce optimal mode when taste is your top concern, as it was designed to produce optimal
results every time. results every time.
1. Plug the temperature probe cord into the temperature probe jack on
the heating base.
2. Insert the temperature probe into the thickest piece of meat or center
of dish without touching any bone or fat.
• The notch in the stoneware allows the lid to close when temperature
probe is plugged in.
NOTE: If the probe is removed from the temperature probe jack during
programming or cooking, the Auto Cook Mode must be reset. The slow
cooker will beep and display PROB OUT until the temperature probe
cord is plugged back into the temperature probe jack.
3. Press the AUTO button to cycle through and select pre-set meat
options from BEEF, POUL (poultry), PRK1 (bone-in pork), PRK2 (boneless
pork), CHIL (chili), or STEW.
4. Press the TEMP button to select LOW or HIGH.
• WARM is ONLY for keeping already cooked food at the perfect serving
temperature . DO NOT cook on the WARM setting.
5. Press the START/STOP button to start cooking.
• The upper display shows the pre-set meat selection, the lower
display shows the internal temperature of the food, and the
corresponding temperature selection illuminates.
• When the internal temperature of the meat reaches the safe
temperature, the slow cooker beeps once, the upper display shows
"SIMR," and the lower display counts down additional cooking time
until the food reaches its optimal taste.
• When the cook time expires, the slow cooker beeps twice, and the
temperature shifts to WARM. The upper display shows WARM and
the lower display is off.
6 QT Smart-Set 08EM1.indd Sec1:7-Sec1:8 6 QT Smart-Set 08EM1.indd Sec1:7-Sec1:8
WARM until it is served. Use this until it is served. Use this
7
Auto Cook Mode (cont.)
• To change any settings after you have already pressed START/STOP,
you must make your new selections and press START/STOP again so
the slow cooker recognizes the new settings.
6. To turn the slow cooker off, press the START/STOP button, then unplug
it from the outlet.
Important Information About the Temperature Probe
• Temperature probe is ONLY for use with Auto Cook Mode. Make sure
it is inserted fully into the probe jack or Auto Cook Mode will not
function correctly.
• Remove probe before cooking with other modes (they will not work
with probe plugged in).
• Do not remove probe from temperature probe jack while cooking or
Auto Cook Mode will not function properly. Leave the temperature
probe in the food throughout the cooking cycle.
• CAUTION: Use oven mitts to remove the temperature probe from the CAUTION:
food as it is HOT!
8
4/17/08 6:21:20 PM 4/17/08 6:21:20 PM