Automatic Exposure Adjustment - Sharp AR-160 Operation Manual

AUTOMATIC EXPOSURE ADJUSTMENT

The automatic exposure level can be adjusted to suit your copying needs.
This level is set for copying from the original table and copying from the
optional SPF respectively. To set the level for the optional SPF, place an
original in the SPF tray and make sure that the SPF indicator lights up
before proceeding to step 1. To set the level for the original table, ensure
that the SPF indicator does not light up.
26
1
Press the AUTO/MANUAL/PHOTO key to select the
PHOTO mode.
2
Press and hold down the AUTO/MANUAL/PHOTO key
for approximately 5 seconds.
The PHOTO indicator will go out and the AUTO indicator will begin
●
to blink.
One or two exposure indicators corresponding to the current automatic
●
exposure level will light up. The factory default setting is level "3".
3
Press the light (
the automatic exposure level as desired.
4
Press the AUTO/MANUAL/PHOTO key.
The AUTO indicator will stop blinking and will light up steadily.
●
This automatic exposure level will remain in effect until you change
●
it again by this procedure.
) or dark ( ) key to lighten or darken