Compaq 158222-B21 - StorageWorks Fibre Channel SAN Switch 8 Release Note page 7

configUpload Telnet Command
An FTP server must be installed and running when performing the Telnet
command configUpload on a Windows NT system. If you do not have a
Microsoft Windows NT FTP server previously installed on your system, you
need to install it.
Perform the following steps to install and configure a Windows NT FTP
server.
1. Create a folder to put the switch firmware and configuration files in.
2. Install the Windows NT FTP server on your system from your
Windows NT installation CD.
If you only use the FTP server for the firmware and configuration loads,
you can specify the folder created in Step 1 as the FTP Publish
Directory.
3. Open the Internet Service Manager Tool found in the Start menu under
Internet Information Service or Peer Web Service.
4. Double-click the FTP service.
5. Clear "Allow Anonymous Connections" if the password-restricted
access is desired.
6. Select the Directories tab then select the folder you created in Step 1. If
this folder was not selected as the root folder add it to the list.
7. Highlight the folder and make sure the read and write boxes are
selected.
8. Close the Internet Service Manager Tool.
9. Perform a configuration save by using the Telnet command configUpload.
In the instructions, the source files that are referred to are the standard
Windows NT server or Workstation CD.
FTP Service uses the standard users defined under Windows NT, so a valid
local user and password is required. A user can be created using the
Windows NT administrative tools.
Appropriate permissions for the created folder (NTFS volumes only) must be
setup to allow the user to have read and write privileges.
Another link that may be used to create a specific directory structure for use of
firmware downloads explains how to create a directory structure for a specific
login, but this is not necessary if FTP is only being used for switch use.
Compaq StorageWorks Fibre Channel SAN Switch 16 Release Notes 7