Simple Network Management Protocol - Dell PowerConnect 3248 Manual

E x a m p l e
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 128
Console(config-if)#spanning-tree cost 19
Console(config-if)#spanning-tree link-type auto
Console(config-if)#no spanning-tree edge-port
Console#spanning-tree protocol-migration ethernet 1/5

Simple Network Management Protocol

The Simple Network Management Protocol (SNMP) page contains a new
link to the following page:
• IP Filtering
IP Filtering
On the SNMP/IP Filtering page, you can create a list of up to 16 IP
addresses or IP address groups that are allowed access to the switch using
SNMP management software.
IP addresses that are permitted SNMP access are specified by an IP address
and a subnet mask that identifies the range of valid addresses. For example:
IP address 192.168.1.1 and mask 255.255.255.0 — Specifies a valid IP
address group from 192.168.1.0 to 192.168.1.255.
IP address 192.168.1.1 and mask 255.255.255.255 — Specifies a valid IP
address of 192.168.1.1 only.
The following options are available:
IP Filter List — Displays a list of the IP address/subnet mask entries
•
currently configured for SNMP access.
• IP address — Specifies a new IP address to add to the IP Filter List.
Subnet Mask — Specifies a single IP address or group of addresses. If
•
the IP is the address of a single management station, the mask should
be set to 255.255.255.255. Otherwise, the IP address group is specified
by the mask.
Addendum to the 3 248 and 52 24 User 's Guides
NOTE: IP filtering does
not affect management
access to the switch using
the Web interface or
Telnet.
35