Dell PowerConnect 3248 Manual page 20

NOTE: To re-enable a
port using the CLI, use
the no shutdown
command in Interface
Configuration mode.
20 Addendum to the 32 48 and 5 224 User 's Guides
The following figure is representative of PowerConnect 3248.
Switch 3248: Re-Enabling a Shutdown Port
If security is enabled on a port and the intrusion action set to Shutdown or
Trap and Shutdown, then a security violation will cause the port to be
disabled. To re-enable a shutdown port, follow these steps:
Click the Ports/Port Configuration page.
1
For the port that is disabled, click the check box in the Admin/Oper
2
column.
Click Apply Changes to enable the port.
3
Switch 3248: CLI Commands
The following table summarizes the equivalent CLI commands for items in
the Ports/Port Security page.
Command
port security [action
{shutdown | trap | trap-
and-shutdown}]
Usage
Enables and configures port security on a port.
The no form command resets the values to the
defaults.