Table of Contents
Advertisement
E.14.3 Converting NetWare 6.5 Clusters to OES 2 Linux
Location
Step 3
in
Section 6.8,
"Finalizing the Cluster
Conversion," on page 88
E.14.4 Managing Clusters
Location
Step 6
in
Section 8.15,
"Deleting a Cluster Node
from a Cluster, or
Reconfiguring a Cluster
Node," on page 109
E.14.5 What's Next
Location
Section 2.3.3, "Behavior
Change for Adding a Node,"
on page 25
Section 2.3.3, "Behavior
Change for Adding a Node,"
on page 25
E.15 February 13, 2009
Errata were corrected. Updates were made to the following section. The changes are explained
below.
Section E.15.1, "Converting NetWare 6.5 Clusters to OES 2 Linux," on page 244
Change
You must restart the cluster so that clstrlib.ko is reloaded:
rcnovell-ncs restart
Change
If you are converting a cluster from NetWare to Linux, you must restart the
cluster instead so that clstrlib.ko is reloaded:
rcnovell-ncs restart
Change
IMPORTANT: A Novell Cluster Services patch is available in the patch
channel and on the
Novell Downloads Web site (http://www.novell.com/
downloads)
that allows you to add a new node seamlessly again on a
Linux server. For cluster conversions, a cluster restart is still necessary
after all NetWare nodes have been removed from the cluster.
If you are converting a cluster from NetWare to Linux, you must restart the
cluster instead so that clstrlib.ko is reloaded:
rcnovell-ncs restart
Documentation Updates 243
Advertisement
Table of Contents
Troubleshooting
